Quick Start Manual

Adding a VueZone

Camera

Visit VueZone.com

NETGEAR, Inc.

350 East Plumeria Drive

San Jose, CA 95134 USA

We’re here to help!

Go to http://support.netgear.com for

product updates and web support.

You can also access support by clicking

the Help link when logged into your

account at my.VueZone.com

What’s in the box

Mounting screw

VueZone Camera Camera mount

Battery

Install camera batteries

Go to http://support.netgear.com for support help.

Slide latch to remove

battery door.

Insert batteries as indicated

with negative terminal ﬁ rst.

Replace battery door and latch.

reserved. NETGEAR, VueZone and the

NETGEAR VueZone logo are trademarks

or registered trademarks of NETGEAR,

Inc. and/or its subsidiaries in the United

States and/or other countries.

Night Vision Lamp

included only with

Night Vision Camera

PAGE 1
Insert batteries as indicated with negative terminal first. Replace battery door and latch. Go to http://support.netgear.com for support help. Night Vision Lamp included only with Night Vision Camera VueZone Camera Camera mount Battery Mounting screw Slide latch to remove battery door. 1 Install camera batteries We’re here to help! Go to http://support.netgear.com for product updates and web support. You can also access support by clicking the Help link when logged into your account at my.VueZone.
PAGE 2
Sync cameras Click the Sync button on top of base station. Blue Sync light will turn on. Hold camera within 12 inches of the base station and slide power switch ON (green dot showing). Blue light on camera front will blink for 5 seconds to confirm sync. NOTE: each time power is turned ON, motion detection cameras require 1 minute for sensor to warm up and operate. Install cameras Peel. Remove strip from adhesive backing on mount. Do not remove if mounting on a screw. Stick.