Owners manual

Advanced Configuration
110
ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
8. (Optional) Specify rate limiting for the classification as described in the following table.
9. Click the Add button.
The classification is added to the Classifications field.
10. To add another classification to the QoS policy, repeat Step 7, Step 8, and Step 9.
11. Click the Apply button.
The QoS policy is saved.
Note: Rate limiting for the WiFi interface is an optional setting that applies to
all traffic on the WiFi interface. Unlike classification rate limiting, which
you can specify for each classification, rate limiting for the WiFi
interface you must specify only once.
Apply
Classification
From the Apply Classification menu, select the traffic class that must be applied to the
packets that match the selection in the Match Classifications field:
• Best Effort(0)
• Background(1)
• Spare(2)
• Excellent(3)
• Control Load(4)
• Video < 100 ms Latency(5)
• Voice < 10 ms Latency(6)
• Network Control(7)
Setting Description
Classification
Rate Limiting
Basic Rate Enter a value between 1 and 1,000,000 Kbytes/sec to specify the
maximum data rate up to which packets that match the classification
are queued for transmission and sent immediately over the WiFi
interface. This value applies only to traffic that matches the
classification.
Note: When the maximum rate is exceeded, packets are retained in
the queue and sent when the transmission falls again below the
maximum rate.
Burst Rate Enter a value between 1 and 204,800,000 bytes to specify the
maximum amount of data that can be transmitted in a burst for packets
that match the classification. This value applies only to traffic that
matches the classification.
Setting Description