Owners manual

Supplemental Information
138
ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
Factory Default Settings
You can use the Reset button located on the rear of the access point to reset all settings to
their factory defaults. This is called a hard reset.
To perform a hard reset, use a sharp object to press and hold the Reset button for
approximately five seconds (until the Test LED blinks rapidly). This returns the access point
to the factory configuration settings that are shown in the following table.
802.11 a-na-ac
encryption
• WPA-PSK & WPA2-PSK
• AES
• TKIP
Management and Other Specifications
Network management • Remote configuration and management through the web management
interface, through SNMP, or through Telnet or SSH with the command-line
interface (CLI).
• SNMP management supports SNMP MIB II, 802.11 MIB and proprietary
configuration MIB.
Maximum clients Limited by the amount of WiFi network traffic generated by each node; a maximum
of 400 clients is supported.
Status LEDs • Power/Test LED
• Activity LED
• Ethernet LAN
• WiFi LAN (2.4 GHz and 5 GHz)
Electrical and Physical Specifications
Power adapter 12 VDC, 2.5A; plug is localized to country of sale
Physical specifications • Dimensions (h x w x d): 197.3 x 197.3 x 40 mm (7.76 x 7.76 x 1.57 in.)
• Weight: 762 g (1.6 lb)
Environmental
specifications
Operating temperature: 0 to 40°C (32 to 131°F)
Operating humidity: 10–90%, noncondensing
Electromagnetic
compliance
• FCC Part 15 SubPart B
• FCC Part 15 SubPart C
• FCC Part 15 SubPart E
• CE
• C-TICK
Table 4. Technical specifications (continued)
Feature Description