Owners manual

Management and Monitoring
63
ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
Use the Web Management Interface to Restore Factory Default Settings
 To restore the factory default settings using the web management interface:
1. Open a web browser from a computer that is connected to the same network as the
access point or to the access point directly through an Ethernet cable.
For more information, see Log In to the Access Point on page 15.
2. In the address bar, enter the IP address of the access point.
A login window opens.
3. Enter the user name and password.
The user name is admin. The default password is password. The user name and
password are case-sensitive.
4. Select Maintenance > Reset > Restore Defaults.
5. Select the Yes radio button.
By default, the No radio button is selected.
IMPORTANT:
During the restoration process, do not try to go online, turn off the
access point, shut down the computer, or do anything else to the
access point until it finishes restarting!
6. Click the Apply button.
The access point is reset to the factory default settings.
During the restoration process, the access point automatically restarts. The restoration
process typically takes about one minute. When the Test LED turns off, wait a few more
seconds before doing anything with the access point.
Use the Reset Button to Restore Factory Default Settings
To restore the factory default settings when you do not know the login user name, login
password, or IP address, you must use the Reset button on the rear panel of the access
point (see Figure 2 on page 8).