Owners manual

Management and Monitoring
57
ProSAFE Dual-Band Wireless AC Access Point WAC720 WAC730
3. Click the Apply button.
The wireless access point is reset to the factory default settings.
During the restoration process, the wireless access point automatically restarts. The
restoration process typically takes about one minute. When the
Test LED turns off, wait a
few more seconds before doing anything with the wireless access point.
Use the Reset Button to Restore Factory Default Settings
To restore the factory default settings when you do not know the login user name, login
password, or IP address, you must use the Reset button on the rear panel of the wireless
access point (see Figure 2 on page 9).
 To restore the factory default settings using the Reset button:
1. Using a sharp object, press and hold the Reset button for about five seconds (until the
Test
LED blinks rapidly) to reset the wireless access point to factory defaults settings.
Note: Pressing the Reset button for a shorter time simply causes the
wireless access point to reboot.
2. Release the Reset button.
During the restoration process, the wireless access point automatically restarts. The
restoration process typically takes about one minute. When the
Test LED turns off, wait a
few more seconds before doing anything with the wireless access point.
Reboot the Wireless Access Point Without Restoring the
Default Configuration
If you do not have physical access to the wireless access point to switch it off and on again,
you can use the software to reboot the wireless access point.
 To reboot the wireless access point:
1. Select Maintenance > Reset > Reboot
AP.
2. Select the Yes radio button. (By default, the No radio button is selected.)
3. Click the Apply button to reboot the wireless access point.