User's Manual
Table Of Contents
- Installation Guide for the Model WG511 802.11g Wireless PC Card
- Contents
- Chapter 1 Introduction
- Chapter 2 Installing the WG511 802.11g Wireless PC Card
- What You Will Need Before You Begin
- Two Basic Operating Modes
- WG511 Default Wireless Configuration Settings
- Using the WG511 to Connect to a Wireless Access Point Network in Infrastructure Mode
- Setup Instructions
- Using the WG511 to Connect in Ad-Hoc Mode
- WG511 Wireless Connection Indicators
- Troubleshooting Tips
- Chapter 3 Protecting Your Wireless Connection
7
Using the WG511 to Connect to a Wireless Access
Point Network in Infrastructure Mode
Figure 2-1: NETGEAR WG511 Wireless PC Card in Infrastructure Mode
This section provides instructions for setting up the WG511 802.11g Wireless PC
Card. The procedures below provide step-by-step installation instructions for
Windows PCs. Use the procedure that corresponds to the version of Windows you
are using.
WG511 Wireless PC Card
in a Notebook Computer
Cable/DSL Router
Cable or DSL modem
Wireless Access Point