Reference Manual

Installation Guide for the NETGEAR 54 Mbps Wireless PC Card WG511
Configuration 3-27
Figure 3-6: Profiles tab page
b. Type a descriptive name for the Profile Name.
c. Click the Save button to save this profile. All the configuration settings are saved
in this profile.
d. Click Activate to activate your settings.
e. Click OK to exit the configuration utility.
3. Configure the PC network settings.
a. Configure each PC with either a static IP address or with the IPX protocol.
Note: For instructions on configuring static IP addresses or the IPX protocol, please refer
to the networking turorial on your NETGEAR 54 Mbps Wireless PC Card WG511
Resource CD.
b. Restart the PCs.
4. Verify wireless connectivity between your peer devices.
Verify connectivity by using the Ping.