User's Manual
Table Of Contents
- Reference Manual for the 54 Mbps Wireless Travel Router WGR101
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Connecting the Router to the Internet
- Chapter 4 Wireless Configuration
- Chapter 5 Management
- Chapter 6 Network Configuration
- Chapter 7 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Network, Routing, Firewall, and Basics
- Appendix C Preparing Your Network
- Appendix D Wireless Networking Basics
- Glossary
- Index
Reference Manual for the 54 Mbps Wireless Travel Router WGR101
7-6 Troubleshooting
May 2004 (202-10034-01)
• Use the Default Reset button on the rear panel of the router. Use this method for cases when
the administration password or IP address is not known.
To restore the factory default configuration settings without knowing the administration password
or IP address, you must use the Default Reset button on the rear panel of the router.
1. Press and hold the Default Reset button until the power light blinks on (about 10 seconds).
2. Release the Default Reset button and wait for the router to reboot.
If the wireless travel router fails to restart or the power light continues to blink or turns solid
amber, the unit may be defective. If the error persists, you might have a hardware problem and
should contact technical support.