Use and Care Manual
Table Of Contents
- ProSafe Wireless-N Access Point WNAP210
- Contents
- 1. Getting Started
- 2. Installation and Configuration
- Wireless Equipment Placement and Range Guidelines
- Prepare to Install the Access Point
- Connect to the Access Point
- Log In to the Access Point
- Configure LAN Settings
- Set Basic IP Options
- Set Up and Test Basic Wireless Connectivity
- QoS Settings
- Deploy the Access Point
- Wireless Security Options
- Security Profiles
- Restrict Wireless Access by MAC Address
- 3. Management
- 4. Monitoring
- 5. Advanced Configuration
- 6. Troubleshooting and Debugging
- A. Supplemental Information
- B. Command Line Reference
- C. Notification of Compliance
- Index

Supplemental Information
64
ProSafe Wireless-N Access Point WNAP210
Spanning Tree Protocol Disabled
Secure Telnet Enabled
Wireless operating mode Access Point
Access point name netgearxxxxxx, where xxxxxx represents the last 6 digits
of the wireless access point MAC address.
Wireless communication Enabled
11 b/g/n wireless network name (SSID) NETGEAR_11ng
Broadcast network name (SSID) Enabled
Security Disabled
Transmission speed Best
a
Country/Region Varies by region
802.11gn Radio Frequency Channel Auto
Output power Full
Wireless card access list All wireless stations allowed
WMM support Enabled
a. Maximum wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will vary. Network conditions
and environmental factors, including volume of network traffic, building materials and construction, and network overhead, lower
actual data throughput rate.
Table 5. Access point default configuration settings (continued)
Feature Default setting