Use and Care Manual
Table Of Contents
- ProSafe Wireless-N Access Point WNAP210
- Contents
- 1. Getting Started
- 2. Installation and Configuration
- Wireless Equipment Placement and Range Guidelines
- Prepare to Install the Access Point
- Connect to the Access Point
- Log In to the Access Point
- Configure LAN Settings
- Set Basic IP Options
- Set Up and Test Basic Wireless Connectivity
- QoS Settings
- Deploy the Access Point
- Wireless Security Options
- Security Profiles
- Restrict Wireless Access by MAC Address
- 3. Management
- 4. Monitoring
- 5. Advanced Configuration
- 6. Troubleshooting and Debugging
- A. Supplemental Information
- B. Command Line Reference
- C. Notification of Compliance
- Index
Getting Started
8
ProSafe Wireless-N Access Point WNAP210
Rear Panel
Power Ethernet Restore
Factory
Settings
Figure 2. Rear panel
The access point rear panel functions are described in the following list:
• Power socket. This socket connects to the 12V 1.0A power adapter.
• RJ-45 Ethernet port. Use the Ethernet RJ-45 port to connect to an Ethernet LAN through
a device such as a hub, switch, router, or PoE switch.
• Restore Factory Settings button. This button restores the access point to the factory
default settings.