Quick Start Manual

Wait approximately 2 minutes
until your modem turns on.
If your modem has a battery backup,
first remove and reinsert the battery
before connecting your
modem to power.
Package Contents:
N300 Wireless Gigabit Router
WNR3500Lv2
Installation Guide
Power adapter
Ethernet cable
Step 1:
Unplug the power
to turn off your modem.
Step 2:
Connect one end of the yellow
Ethernet cable ( ) to your modem,
and the other end to the Internet port
on your router.
Plug in, then turn on your modem.
Step 3:
Step 6:
Step 4:
Connect the power adapter ( )
to the router, then plug it into an
If none of the LEDs turn on, make sure that
the Power On/Off button is in the ON position
(pushed in).
outlet. Wait until the wireless LED
turns solid blue.
Step 5:
Connect your computer
to the router.
Use another Ethernet cable to establish
a wired connection as shown in this diagram.
Optionally, connect wirelessly by using the
preset wireless security settings
located on the bottom label.
Open a browser.
If the Web page does not display,
close and re-open the browser
and enter http://routerlogin.net in
the address bar, or check the
“Troubleshooting” section on
the back of this installation guide.
Laptop or Desktop
Computer
NETGEAR
N300 Wireless Router
Modem
or Cable
Internet
DSL
N300 Wireless Router
(not included)
Power On/Off