User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure System Information User Manual111
10. Click the Apply button.
Your settings are saved.
The Hit Count field displays the number of UDP packets that are detected on the UDP
port.
Configure UDP Relay Interface Settings
To configure UDP Relay Interface settings:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select System > Services > UDP Relay > UDP Relay Interface Configuration.
5. Use Interface to select an Interface to be enabled for the UDP Relay.
6. Use Server Address to specify the UDP Relay Server
Address in x.x.x.x format.
7. Use UDP Port to specify UDP Destination Port.
The following ports are supported:
• DefaultSet. Relay UDP port 0 packets.
This is specified if no UDP port is selected
when creating a Relay server.
• dhcp. Relay DHCP (UDP port 67) packets.
• domain. Relay DNS (UDP port 53) packets.
• isakmp. Relay ISAKMP (UDP port 500) packets.
• mobile-ip. Relay Mobile IP (UDP port 434) packets
• nameserver. Relay IEN-1
16 Name Service (UDP port 42) packets
• netbios-dgm. Relay NetBIOS Datagram Server (UDP port 138) packets
• netbios-ns. Relay NetBIOS Name Server (UDP port 137) packets
• ntp. Relay network time protocol (UDP port 123) packets.