User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Switching Information User Manual214
Note: For two bridges to be in the same region, the force version must be
802.1s and their configuration name, digest key, and revision level
must match. For additional information about regions and their effect
on network topology, refer to the IEEE 802.1Q standard.
Configure Basic STP Settings
To configure STP basic settings:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Switching > STP > Basic > STP Configuration.
5. Select the Spanning T
ree Admin Mode Disable or Enable radio button.
This specifies whether spanning tree operation is enabled on the switch.
6. Use Force Protocol V
ersion to specify the Force Protocol Version parameter for the
switch.