User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Switching Information User Manual260
6. Use Querier Address to specify the snooping querier address to be used as source
address in periodic MLD queries.
This address is used when no address is configured on the VLAN on which query is being
sent.
The supported IPv6 formats are x:x:x:x:x:x:x:x and x::x.
7. Use MLD Version to specify the MLD protocol version used in periodic MLD queries.
8. Use Query Interval(secs) to specify the time interval in seconds between periodic queries
sent by the snooping querier
.
The query interval must be a value in the range of 1 to 1800. The default value is 60.
9. Use Querier Expiry Interval(secs) to specify the time interval in seconds after which the
last querier information is removed.
The querier expiry Interval must be a value in the range of 60 to 300. The default value is
60.
The page displays VLAN IDs enabled for the MLD snooping querier.
10. Click the Apply button.
Your settings are saved.
Configure MLD Snooping Querier VLAN Settings
To configure MLD snooping querier VLAN settings:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Switching> Multicast > MLD Snooping > Querier VLAN Configuration.
5. Use VLAN ID to select the VLAN ID on which the MLD snooping querier is administratively
enabled and a VLAN exists in the VLAN database.
6. Use Querier Election Participate Mode to enable or disable the MLD snooping querier
participation in election mode.