User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Switching Information User Manual282
Configure LAG Membership
You can select two or more full-duplex Ethernet links to be aggregated together to form a link
aggregation group (LAG), which is also known as a port-channel. The switch can treat the
port-channel as if it were a single link.
To configure LAG membership:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Switching> LAG > LAG Membership.
5. Use LAG ID to select the identification of the LAG.
6. Use LAG Name to enter the name to be assigned to the LAG.
You can enter any string of up to 15 alphanumeric characters. A valid name must be
specified for you to create the LAG.
7. Use LAG Description to enter the description string to be attached to a LAG.
It can be up to 64 characters in length.
8. Use Admin Mode to select Enable or Disable.
When the LAG is disabled, no traffic flows and LACPDUs are dropped, but the links that
form the LAG are not released.
The factory default is Enable.
9. Use Link Trap to specify whether to send a trap when the link status changes.