User Manual

Table Of Contents

M4300 Intelligent Edge Series Fully Managed Stackable Switches

Maintenance and Troubleshooting User Manual684

5. Use Source Image to select the image1 or image2 as the source image (the image to be

copied).

6. Use Switch Member to select the destination unit to which you are going to copy from the

supervisor

7. Use Destination Image to select the image1 or image2 as the destination image.

8. Click the Apply button.

The image is copied.

Configure Dual Image Settings

The Dual Image feature allows the switch to retain two images in permanent storage. The

administrator can designate image1 or image2 as the active image to be loaded during

subsequent switch restarts. This feature reduces switch down time when you are upgrading

or downgrading the software image.

To configure dual image settings:

1. Launch a web browser

2. In the address field of your web browser

, enter the IP address of the switch.

The login window opens.

3. Enter admin as the user name, enter your local device password,

and click the Login

button.

The first time that you log in, no password is required. However, you then must specify a

local device password to use each subsequent time that you log in.

The System Information page displays.

4. Select Maintenance > File Management > Dual Image Configuration.