User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Manage Switch Security User Manual508
Configure a RADIUS Server
To configure a RADIUS server:
1. Launch a web browser.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Security > Management Security> RADIUS > Server Configuration.
5. T
o add a RADIUS server, specify the following settings:
• In the Radius Server IP
Address field, specify the IP address of the RADIUS server.
• In the Radius Server Name field, specify the name of the server
.
• Use Port to specify the UDP port used by this server
. The valid range is 0–65535.
• Secret Configured.
The secret is applied only if this option is Yes. If the option is No,
anything entered in the secret field has no effect and is not retained.
• Use Secret to specify the shared secret for this server
.
• Use Primary Server to set the selected server as a primary or secondary server
.
• Use Message Authenticator to enable or disable the message authenticator attribute
for the selected server
.
6. Click the Add button.
The server is added to the switch.
The Current field indicates if the server is currently in use as the authentication server
.