User Manual

24
Figure 12. SNMP configuration for version 3
Enable SNMP Enables SNMP functions in the system kernel.
Port Port where the device listens for SNMP M2M API commands.
Range: 1 – 65535. The device warns you if you specify a port number
that is already in use. However, to be sure, we recommend using either
the standard SNMP port 161, or port numbers above 1024.
SNMP version 1,2c – unsecured, unencrypted. Generally used to monitor the device.
3 – complex security via encryption and authentication. Can be used to
write values / control output states.
Community
v1,2c only
Also called the “community string” in SNMP. Similar to a
username/password combination. Needed for reading information from
NETIO 4x over SNMP.
We recommend to use “pure” ASCII characters (that is, to avoid
accented and special characters, such as @, & and so on, if possible).