User Manual

56
In the Wi-Fi Access point mode, your NETIO 4/4All is connected via the Ethernet (primary network
interface) just as in the Cable mode. However, it also serves as a Wi-Fi access point. Other devices
can connect to your NETIO 4/4All over Wi-Fi (secondary network interface) and gain access to the
Ethernet network (bridging between Ethernet and Wi-Fi takes place). In this mode, NETIO 4/4All
does NOT provide DHCP on any network interface.
After selecting this mode, the IP parameters need to be configured. NETIO 4/4All will be accessible
at this address from both the Ethernet and the Wi-Fi network. After the configuration is finished,
these settings are accessible in the Settings/Network Configuration submenu. For a detailed
description of these parameters, see the Settings/Network configuration section.
Figure 34. Configuring the Wi-Fi network IP parameters in the Wi-Fi Access Point mode
After saving the IP configuration, the parameters for the Wi-Fi Access Point mode need to be set.
After the configuration is finished, these settings are accessible in the Settings/Wi-Fi submenu. For
a detailed description of these parameters, see the Settings/Wi-Fi settings section.