User Manual

4.5 Restoring factory defaults

This operation deletes all user settings and restores the configuration to the factory defaults. It is

useful when the device is in an unknown state or does not behave as described in this manual.

Procedure:

1. Turn off (unplug) the PowerPDU from power grid.

2. Press and hold the button.

3. Connect the device plug to the power grid (button is still pushed) and wait at least 10 until the

yellow LED on the RJ45 jack flashes 3 times, release the button.

4. The device reverts to the factory settings.

Forgotten password

The reset to factory defaults is also used when the password has been forgotten. After

restoring the factory defaults, the username and password to access the PowerPDU will

be “admin” / “admin”.

4.6 Controlling the output manually

The outputs can be switched on/off (toggled) by pressing the button quickly 3 times in a row.

1. Press the “SETUP” or “TGL/RESET” button three times fast to toggle the outputs.

Note: If at least one output is ON the “toggle” by button change all outputs to OFF. If all outputs

are OFF the “toggle” change all to ON.