User Manual

5.1.3 Outputs - Schedule

The Scheduler function can be used to switch the output on and off at specified times. Select a

schedule to specify when the output should be turned on. After selecting a schedule, the on-times

for the output according to that schedule are shown graphically. Check Enable schedule if you want

enable scheduler and Click Save Changes to confirm changes. If the Scheduler is enabled the current

interval is applied so the output state may change according to selected schedule.

The displayed schedule cannot be changed in the Output – Schedule view. To change a schedule, click

Edit schedules. It opens the main tab Schedules (details in chapter Schedules).

To enable or disable the Scheduler for a given output, you may also click the Scheduler button

next to that output. When the Scheduler function is disabled, the outputs stay in their current

states. When it is enabled, the outputs are set according to the schedule.

The Scheduler button / icon next the output indicates Enabled (green) or Disabled (grey)

Sehduler function.

Note: When the Scheduler feature is Enabled for specific Output then the PowerUp state is ignored

on this Output. The output stays off after power up without Ethernet connection or until the

time is synchronized from NTP server. The Scheduler is waiting for the valid time from NTP

and this needs Ethernet/Internet connection. It is to respect schedule if state change occurred

during the power outage and prevents against for example short power on "peek".

Figure 19 – Configuring the Schedule

Scheduler on output 4 disabled

Scheduler on output 1 enabled