User Manual

5.4 Open API: M2M Protocols

All M2M protocols use the same values for the action parameter to control the output. Allowed

values are:

0 – turns the output off

1 – turns the output on

2 – short OFF – turns the output off for a short

time (if the output was off, it will be turned on)

3 – short ON – turns the output on for a short

time (if the output was on, it will be turned off)

4 – toggle – toggles the current output state

5 – no operation – leaves the output unchanged

6 – ignore – ignores the action attribute and only respects the state attribute – only for XML and

JSON

Only one M2M protocol in addition to SNMP can be active at any time!

Following M2M API Protocols cannot run in parallel to NETIO Cloud Connection:

 MQTT-flex

 Netio Push

The notification message appears if you try to enable unsupported combination.

The short-off/short-on duration can be also specified in the command issued over the respective M2M protocol. If

unspecified, the “Short ON/OFF delay” value is used.