User Manual

5.4.1 M2M API Protocol – XML over HTTP

Figure 22 – XML API protocol configuration

Enable XML API

Enables M2M XML API functions in the system.

Port

Read-only value. Indicates the port where the device currently listens

for M2M XML API commands. This port is the same for all http based M2M

API protocols and web administration and can be changed in Settings /

System (chapter System).

Enable READ-ONLY

Enables Read-Only access via M2M XML API for monitoring. You may also

fill in the username and password for this mode.

Enable READ-WRITE

Enables Read/Write access for monitoring (reading values) and writing

(output control). You may also fill in the username and password for this

mode.

Username

Username for the respective access mode (Read-Only/ReadWrite). Note

– this is unrelated to the username for accessing the NETIO 4x web

administration interface. When left empty, the protocol will not require

any authentication.

Password

Password for the corresponding username (Read-Only/ReadWrite).