User's Manual

Wireless Access Point User m anual
Page 15 of 15
Figure 13
5 .2 Addit ional Se t t in gs for W irele ss Client
I f you chose t o access the AP via a wireless client, also verify the following:
St ep 1: Make sure your PC is equipped with 802.11g or 802.11b wireless
adapter and has appropriate WLAN card driver/ ut ilit y and TCP/ I P installed.
St ep 2: Set t he wireless adapter to use appropriat e TCP/ I P set tings as
described in previous sect ion.
St ep 3: Launch t he wireless adapter’s provided utility and verify t hat your
wireless client is configured wit h these sett ings:

Operation Mode: I nfrast ruct ure

SSI D: default

Aut hent ication: Disabled
 Encrypt ion: Off
 Radio Band: 802.11B/ G
I f you only finished t he wireless set t ings and didn’t configure t he wireless
adapter’s TCP/ I P set tings, even your link status indicates a successful
connection wit h the AP. This connection applies to the “ physical” net work layer