User's Manual

Wireless Access Point User m anual
Page 16 of 16
only. Your wireless adapter cannot com m unicat e wit h the AP. Make sure to set
the TCP/ I P properties as described in t his previous section.
5 .3 Check ing PC’s I P and Connect ion w it h t he AP
After configuring the TCP/ I P prot ocol, use the ping com m and t o verify if t he
com puter can com m unicate wit h the AP. To execut e the ping com m and, open
the DOS window and PI NG t he I P address of the Wireless Access Point at the
DOS prom pt:

For Windows 98/ Me: Start - > Run. Type “com m an d” and click OK.
 For Windows 2000/ XP: Start -> Run. Type “cm d” and click OK.
At t he DOS prom pt, t ype the following com m and:
I f t he Com m and window returns som et hing sim ilar t o t he following:
Figure 14
Then t he connect ion bet ween t he AP and your com put er has been successfully
established.
I f the com put er fails to connect t o t he AP, t he Com m and window will r et urn the
follow ing: