User's Manual

Wireless Access Point User m anual
Page 5 of 5
To reset the AP t o t he factory default s, press and hold the Reset butt on for
m ore t han five seconds. This clears t he AP’s user set t ings, including User I D,
Password, I P Address, and Subnet m ask. (Warning: your original
configurations will be replaced with t he fact ory default sett ings)
3 .2 LED Descript ion
The following illust ration shows the Wireless Access Point front panel:
Figure 2 fr ont panel
Number LED Light Status Description
1 PWR ON This indicator light s green when the
Wireless AP is receiving power;
ot herw ise, it is off.
2 CPU ON The LED will be dark for a few seconds
when the system is st art ed. Aft er t hat ,
the LED will stays green t o show the
Wireless AP is working norm ally. I f t he
LED stays blink/ dark t hat m eans the
system failed, you need to cont act your
agent or t ry t o reboot t he system .
3 LAN Link Flashing LAN is connect ed.
4 LAN
Speed
Flashing LAN has Activit y ( ACT) dat a being sent or
Received
5 LAN
RX/ TX
Flashing LAN has Activit y ( ACT) dat a being sent or
Received.
6 Wireless
RX/ TX
Flashing Wireless has Activit y ( ACT) dat a being
sent or Received.