User's Manual

Wireless Broadband Router User Manual
Page 13 of 40
Figure - 14
2.3.2 Additional Settings for Wireless Client
If you choose to access the router via a wireless client, also verify the following:
1. Make sure your PC is equipped with 802.11n, 802.11g or 802.11b wireless adapter and
has appropriate WLAN card driver/utility and TCP/IP installed.
2. Set the wireless adapter to use appropriate TCP/IP settings as described in previous
section.
3. Launch the wireless adapter’s provided utility and verify that your wireless client is
configured with these settings:
z Operation Mode: Infrastructure
z SSID: default
z Authentication: Disabled
z Encryption: Off
z Radio Band: 802.11B/G
If you only finished the wireless settings and didn’t configure the wireless
adapter’s TCP/IP settings, even your link status indicates a successful connection with
the AP, this connection applies to the “physical” network layer only. Your wireless
adapter cannot communicate with the AP. Make sure to set the TCP/IP properties as
described in this previous section.