User's Manual

Wireless Broadband Router User Manual
Page 21 of 40
Connection Type(ISP) ：Display router’s current connection type, It should be one of
“PPPoE” ,”DHCP”, “Static IP”, depending on what kind of connection type your ISP provides.
Physical Address：The MAC address of WAN port, this is a unique address assigned by
manufacturer.
IP Address：The IP address you obtained after connect to the Internet, if you haven’t
connected to the Internet yet, this field is blank.
Subnet Mask ：The Subnet mask you obtained after connect to the Internet, if you haven’t
connected to Internet yet, this field is blank.
Default Gateway：The IP address of Default gateway you obtained after connect to the
Internet, if you haven’t connected to Internet yet, this field is blank.
Primary DNS：The DNS server translates domain or website names into IP address, input the
most common DNS server address you used or provided by your ISP.
Secondary DNS：Input IP address of a backup DNS server, or you can leave this field blank.
MTU：The MTU (Maximum Transmission Unit) setting specifies the largest packet size
permitted for network transmission. Most DSL users should use the value 1492.You can set
MTU manually, and you should leave this value in the 1200 to 1500 range. If the value you set
is not in accord with the value ISP provide, it may causes some problems, such as fail to send
Email, or fail to browse website. So if that happen, you can contact your ISP for more
information and correct your router’s MTU value.
Current Version ：The version information of your current firmware.
z LAN Info:
Figure - 23
This item provides information about router’s LAN port, display LAN port’s MAC address, IP
address and current situation of DHCP server.
z Primary AP Info: