User's Manual

Wireless Broadband Router User Manual
Page 23 of 40
Figure - 26
System Run Time: Display System Run Time.
Statistics: This item provides statistics information about the bits router sends and
received.
4.3 Internet Setup
4.3.1 DHCP User(cable modem)
The default setting for the router, DHCP is most commonly used for cable modem
connections. There is no configuration necessary for this setting because the ISP
automatically supplies the information. Choose this type when Cable mode is used.
Figure - 27
Clone MAC：The WAN port of router has a unique MAC address assigned by manufacturer; it
called as “Default MAC”. The “Clone MAC” is used for some special situations; For example,
ISP only allows certain MAC address to access the Internet, thus you can modify your WAN
port’s MAC address in accord with the requirement of ISP, avoiding ISP’s detection.
MTU：The MTU (Maximum Transmission Unit) setting specifies the largest packet size
permitted for network transmission. Most DSL users should use the value 1492.You can set