User's Manual

Wireless Broadband Router User Manual
Page 25 of 40
z Default MAC: Check "Default MAC" to restore the default MAC address of the WAN
interface.
z MTU: MTU is the Maximum Transmission Unit. It specifies the largest packet size
permitted for Internet transmission. Enter your MTU number in the text-box to set the
limitation. The default value or MTU is 1492 and use 1300 for the line condition is bad.
z DNS: Check "DNS" and enter the IP address to specify DNS server for LAN DHCP
server.
z Connection Type: Select your PPPoE connection from these options:
¾ Auto connect: This feature will keep your Internet connection always alive.
the Router will periodically check your Internet connection. If you are
disconnected, then the Router will automatically re-establish your connection.
To use this option, click the radio button next to Auto Connect.
¾ Connect on demand: If enabled, the router will trigger a PPPoE session for
connection to the Internet if any client PC on your WLAN/LAN sends out a
request for Internet access. However, the router automatically disconnects
the PPPoE session after the WAN connection has been idle for the amount of
time you specified in the timeout box (default, 3 minutes). If your Internet
account is billed based on the amount of time of your Internet connection, you
probably want to enable this option and enter an idle time value best suitable
for your network. To use this option, click the radio button next to Connect on
demand.
¾ Connect manually: The router will connect to Internet only when you click
“Connect” manually from the Web user interface. And the WAN connection
will disconnect. If you click “Disconnect” manually from the Web user
interface. the router will not auto-connect to the Internet. To use this option,
click the radio button next to Connect on demand.
z Click “Apply” to save these settings with the Router. The System will apply the new
settings and start rebooting right away. After reboot, the Wireless Router will enable
these settings with the Router.
4.3.3 Static User
If you are required to use a permanent IP address to connect to the Internet, select Static IP.