Manual

VS4X1
NetMedia, Inc., 10940 N. Stallard Place, Tucson, Arizona 85737 [phone] Fax: [phone] Email: [e-mail] www.netmedia.com
MAN-VS4X1 REV0704A
Figure 3 - Connecting the switcher to 4 video sources and a monitor.
VS4X1
Figure 2 - DIP Switch Bank settings for dwell time and input sources (0 = OFF and 1 = ON).
Figure 1 - Switch Bank default setup
4 inputs @ 4 sec. each.
OFF OFF OFF ON OFF OFF ON ON
0 0 0 1 0 0 1 1
Installation Procedures:
1. If changing the default setup from 4 inputs rotating at 4 seconds each, discon-
nect power and remove End Plate opposite Power Connector. Slide out circuit
board to access Switch Bank: switches 1-6 set the dwell time; switches 7-8 set
input sources (Figures 1 & 2). Replace End Plate when finished.
2. Connect video sources to yellow Video Input Connectors (Input 1 is next to
Power Connector).
3. Connect video destination to black Video Output Connector (next to Input 1).
4. Connect 12V DC 100mA power supply to an AC outlet and Power Connector.
5. Switcher output is now available for viewing on monitoring device.
O
N
DIP
Inputs
1 2 3 4 5 6 7 8
Dwell
000000 N/A 010000 16 100000 32 110000 48
000001 1 010001 17 100001 33 110001 49
000010 2 010010 18 100010 34 110010 50
000011 3 010011 19 100011 35 110011 51
000100 4 010100 20 100100 36 110100 52
000101 5 010101 21 100101 37 110101 53
000110 6 010110 22 100110 38 110110 54
000111 7 010111 23 100111 39 110111 55
001000 8 011000 24 101000 40 111000 56
001001 9 011001 25 101001 41 111001 57
001010 10 011010 26 101010 42 111010 58
001011 11 011011 27 101011 43 111011 59
001100 12 011100 28 101100 44 111100 60
001101 13 011101 29 101101 45 111101 61
001110 14 011110 30 101110 46 111110 62
001111 15 011111 31 101111 47 111111 63
00 N/A
01 2
10 3
11 4
Switch
123456
Switch
123456
Switch
123456
Switch
123456
Switch
78
Dwell
Seconds
Dwell
Seconds
Dwell
Seconds
Dwell
Seconds
Input
Sources
Input 1
Output
Input 2
Input 3
Input 4
Power
Camera
Camera
Camera
Camera
Monitor or
Television
Video Switcher