User's Guide

15 16
· Check whether the system sound volume is set High or
Low. It’ll be mute if set so.
Night vision LED may be ON. Please turn on room lights
to force it out of the night mode.
· Check whether the camera is near the monitor and that
there’re no obstacles between them.
· Adjust the monitor antenna to vertical position for
better signal transfer.
· Volume may be set too high. Press Menu Button -> OK
Button -> Left Button to volume down.
· The camera and monitor may be put too close; keep
them at least 1.5m / 4.9ft apart.
· The camera may be too out of range. Please keep it
within 10m / 32.8ft to the monitor.
No sound from
the monitor?
Black and white
pictures?
Choppy videos?
Too much noise?
changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC STATEMENT