Owner manual

5-28 Firmware User Guide
Select Output Filter 2 and press Return. In the Change Output Filter 2 screen, set the Protocol Type to allow
GRE as shown below.
ATMP example
To enable a firewall to allow ATMP traffic, you must provision the firewall to allow inbound and outbound UDP
packets specifically destined for port 5150. The source por t may be dynamic, so often it is not useful to apply
a compare function on this portion of the control/negotiation packets. You must also set the firewall to allow
inbound and outbound GRE packets (Protocol 47, Internet Assigned Numbers Document, RFC 1700), enabling
transport of the tunnel payload.
From the Main Menu navigate to Display/Change IP Filter Set, and from the pop-up menu select Basic Firewall.
Change Output Filter 1
Enabled: Yes
Forward: Yes
Call Placement/Idle Reset: No Change
Force Routing: No
Source IP Address: 0.0.0.0
Source IP Address Mask: 0.0.0.0
Dest. IP Address: 0.0.0.0
Dest. IP Address Mask: 0.0.0.0
TOS: 0
TOS Mask: 0
Protocol Type: TCP
Source Port Compare... No Compare
Source Port ID: 0
Dest. Port Compare... Equal
Dest. Port ID: 1723
Established TCP Conns. Only: No
Return/Enter accepts * Tab toggles * ESC cancels.
Enter the packet specific information for this filter.
Change Output Filter 2
Enabled: Yes
Forward: Yes
Call Placement/Idle Reset: No Change
Force Routing: No
Source IP Address: 0.0.0.0
Source IP Address Mask: 0.0.0.0
Dest. IP Address: 0.0.0.0
Dest. IP Address Mask: 0.0.0.0
TOS: 0
TOS Mask: 0
Protocol Type: GRE
Return/Enter accepts * Tab toggles * ESC cancels.
Enter the packet specific information for this filter.