- Motorola Command Line Interface Command Reference Manual

Motorola Netopia® Router CLI Commands 2-89
Example:
#show wireless statistics
Wireless Statistics
Wireless Protocol: IEEE 802.11b/g
Wireless MAC Addr: 00-00-c5-ca-59-94
Network ID (SSID): 6245 4521 (Open, No privacy)
Operating Channel: 6
Transmit OK : 16
Receive OK : 0
Tx Errors : 0
Rx Errors : 0
Rx No Message : 0
Rx Octets : 0
Rx Unicast Pkts : 0
Rx Multicast Pkts : 0
Tx Discards : 0
Tx Octets : 5326
Tx Unicast Pkts : 0
Tx Multicast Pkts : 0
802.11g Chipset: Texas Instruments TNETW-1130
RX Frames: 0
TX Frames: 0
Free MSDU: 170 of 170 MSDU Free Watermark: 166
Free BD: 340 of 340 BD Free Watermark: 336
# Out of Packets: 0 # Out of BDs: 0
# TX Queue Full: 0
wireless default-channel [ no 1..14 ]
show wireless default-channel
These commands allow you to specify or show a frequency range within the 2.4Ghz band on which this wireless
network will operate. Channel selection depends on government-regulated radio frequencies that vary from
region to region. The widest range available is from 1 – 14; in North America, however, only 1 to 11 may be
selected. Channel selection can have a significant impact on performance, depending on other wireless activity
in proximity to this access point. Channel selection is not necessary at the clients; clients will scan the
available channels and look for access points using the same SSID as the client.