- Motorola Command Line Interface Command Reference Manual

Motorola Netopia® Router CLI Commands 2-129
IKE Dead Peer Detection
Note: The commands in this section are supported beginning with Firmware Version 8.5.2.
ike phase1 { name | index } dead-peer-detection enable { yes | no }
show ike phase1 { name | index } dead-peer-detection enable
no ike phase1 { name | index } dead-peer-detection enable
These commands allow you to enable, disable, or show the status of the traffic-based IKE dead peer detection
feature. Traffic-based IKE dead peer detection allows IKE to negotiate RFC3706-based IKE “keepalives” with a
remote security gateway (IKE peer) that supports them. Default is no (disabled).
show ike phase1 { name | index } dead-peer-detection timeout
ike phase1 { name | index } dead-peer-detection timeout { 3-65535 }
These commands allow you to specify or show an interval, from 3 to 65535 seconds, during which IPSec traffic
may be idle before the router sends a keepalive message to its peer, when ike phase1 dead-peer-detection
enable is set to yes. Default is 20 (seconds).
IKE Dead Peer Detection Configuration Commands
ike phase1 { name | index } dead-peer-detection enable { yes | no }
show ike phase1 { name | index } dead-peer-detection enable
no ike phase1 { name | index } dead-peer-detection enable
show ike phase1 { name | index } dead-peer-detection timeout
ike phase1 { name | index } dead-peer-detection timeout { 3-65535 }