- Motorola Command Line Interface Command Reference Manual

Motorola Netopia® Router Connection Proﬁle Commands 3-33

Note: It is a run-time checked error if both of the IKE Phase 2 SA lifetime values for a particular protocol are

set to zero or none.

ICMP Dead Peer Detection Commands

Beginning with the version 8.2 ﬁrmware release, the Command Line Interface supports the following new and

modiﬁed Connection Proﬁle conﬁguration commands:

cp { name | index } ipsec dead-peer-detection enable { yes | no }

no cp { name | index } ipsec dead-peer-detection

show cp { name | index } ipsec dead-peer-detection enable

These commands allow you to enable, disable, or show the status of the ICMP Dead Peer Detection feature.

The no cp… command is equivalent to specifying the no option.

cp { name | index } ipsec dead-peer-detection ping-address remote net IPv4 address

show cp { name | index } ipsec dead-peer-detection ping-address

These commands allow you to specify or show the IP destination host address that will be used to verify if the

peer is dead or not. The IP address must belong to a tunnel’s remote network. A tunnel’s remote network can

be conﬁgured as a subnet, an address range, or an individual host. The subnet remote network case also

disallows the host part of the address to be all ones or all zeroes. For example, the addresses 163.176.0.0 or

163.176.255.255 are not permitted in a class B network.

cp { name | index } ipsec dead-peer-detection ping-retry 1...65535

show cp { name | index } ipsec dead-peer-detection ping-retry

These commands allow you to specify or show the retry interval between successive pings (in seconds).

Default is 5 seconds.

IKE/IPSec Dead Peer Detection Connection Proﬁle Commands