- Motorola Command Line Interface Command Reference Manual

Motorola Netopia® Router CLI Commands 2-57
diffserv rule id priority [ off | assure | expedite ]
This command allows you to specify the priority for the rule id: off, assure, or expedite. This is the Quality of
Service setting for the rule, based on the TOS bit information. The following table outlines the TOS bit settings
and behavior:
diffserv rule id direction [ outbound | inbound | both ]
This command allows you to specify the direction of the flow: outbound, inbound, or both. For TCP or UDP
protocols, you can optionally specify a range of ports.
diffserv rule id start-port [ 0 - 49151 ]
This command allows you to specify the starting port in the range for the rule id for TCP or UDP protocols.
diffserv rule id end-port [ 0 - 49151 ]
This command allows you to specify the ending port in the range for the rule id for TCP or UDP protocols.
diffserv rule id inside-ip x.x.x.x
This command allows you to specify the inside IP address for the rule id. For outbound flows, specify an IP
address on your LAN. For inbound flows, this setting is ignored.
diffserv rule id outside-ip y.y.y.y
This command allows you to specify the outside IP address for the rule id. If you want traffic destined for and
originating from a certain WAN IP address to be controlled, enter the IP address here. If you specify all-zeroes,
the outside address check is ignored.
For outbound flows, the outside address is the destination IP address for traffic; for inbound packets, the
outside address is the source IP address.
QoS Setting TOS Bit Value Behavior
off TOS=000 This custom rule is disabled. You can activate it by selecting one of
the two settings below. This setting allows you to pre-define flows
without actually activating them.
assure TOS=001 Use normal queuing and throughput rules, but do not drop packets
if possible. Appropriate for applications with no guaranteed delivery
mechanism.
expedite TOS=101 Use minimum delay. Appropriate for VoIP and video applications.