Network Router User Manual
Table Of Contents
- Contents
- Introduction
- Making the Physical Connections
- Connecting to Your Local Area Network
- Configuring TCP/IP
- Console-Based Management
- WAN and System Configuration
- Monitoring Tools
- Security
- Utilities and Diagnostics
- Troubleshooting
- Binary Conversion Table
- Further Reading
- Technical Specifications and Safety Information
- Glossary
- Index
- Limited Warranty and Limitation of Remedies
6-40 User’s Reference Guide
SS
SS
yy
yy
ss
ss
tt
tt
ee
ee
mm
mm
CC
CC
oo
oo
nn
nn
ff
ff
ii
ii
gg
gg
uu
uu
rr
rr
aa
aa
tt
tt
ii
ii
oo
oo
nn
nn
ss
ss
cc
cc
rr
rr
ee
ee
ee
ee
nn
nn
ss
ss
You can connect to the Netopia D-Series’s system configuration screens in either of two ways:
■ By using Telnet with the Netopia D-Series’s Ethernet port IP address. The default is 192.168.1.1, subnet
mask 255.255.255.0.
■ Through the console port, using a local terminal (see “Connecting a console cable to your Netopia
D-Series” on page 5-36)
You can also retrieve the Netopia D-Series’s configuration information and remotely set its parameters using
the Simple Network Management Protocol (see “SNMP” on page 7-57).
Open a Telnet connection to the Netopia D-Series’s IP address; for example, the default “192.168.1.1.”
The console screen will open to the Main Menu, similar to the screen shown below:
Note: Although it references the Netopia D3232, this screen applies to all Netopia D-Series DSL DSUs.
Netopia D3232 v4.6
WAN Configuration...
System Configuration...
Utilities & Diagnostics...
Statistics & Logs...
Quick View...
Return/Enter displays options for the system.
You always start from this main screen.