User Manual

SRU Installation
2-12 SRU Inst allat ion Manual 17286-1000 Rev. B 03/14/01
2.4 Out door Inst allat ion of SRU w it h
N on-Inte gra l Ante nna
The high-performance, non-integral antenna version of the radio unit consists of a parabolic
antenna, shroud and radome. The feed assembly has rectangular waveguide. Two sizes of
antennae are available, 0.3 m or 0.6 m.
2.4 .1
2.4 .12.4 .1
2.4 .1 Inst alling t he Ra dio Unit & Ante nna
Inst alling t he Ra dio Unit & Ante nnaInst alling t he Ra dio Unit & Ante nna
Inst alling t he Ra dio Unit & Ante nna
2.4 .1.1
2.4 .1.12.4 .1.1
2.4 .1.1 General
GeneralGeneral
General
The following installation instructions are provided for the installation of a Non-Integral
Antenna (SlimLine) radio unit with the antennas that are offered for it. Prior to installation,
it is suggested that this entire procedure be read and understood. Thorough preparation is
essential prior to commencing the actual installation.
NTR98-330
Cable Routing
18” Service Loop
Tie-Wrap
SlimLine
Radio Unit
Antenna
Radio Lifting
Handle
Radio
Mounting
Latches
(x4)
Drip Point
Figure 2-9 Finished SlimLine Radio Mounting: Rear View
The radio/antenna assembly is normally mounted on a pole attached to a building rooftop,
wall or parapet. Shown in Figure 2-10 to E rror! Reference source not found. are typical
mountings for these environments. In each case, the mounting structure is bolted to the
building using fasteners according to local building regulations. The radio/antenna
assembly is then bolted to the mounting structure.