User Manual

SRU Installation
17286-1000 Rev. B 03/14/01
SRU Inst alla tion Manual
2-17
2.4 .4
2.4 .42.4 .4
2.4 .4 Inst alling t he M ount
Inst alling t he M ountInst alling t he M ount
Inst alling t he M ount
The following instructions provide details on two typical installation scenarios.
2.4 .4.1
2.4 .4.12.4 .4.1
2.4 .4.1 Direct Asse mbly at Final Mounting Posit ion
Direct Asse mbly at Final Mounting Posit ionDirect Asse mbly at Fina l Mount ing Position
Direct Asse mbly at Final Mounting Posit ion
When access to the mounting pole is unobstructed and at a comfortable working height, use
the following procedure:
Install the antenna pole mount as shown in the relevant installation drawing using the
V-clamps and associated hardware (see Figure 2-14).
Figure 2-14 Installing the Non-Integral Antenna Pole Mount
1.
Mount the antenna/bracket assembly as shown in Figure 2-15.
Figure 2-15 Attaching the Non-Integral Antenna to the Pole Mount
Lift the radio to the antenna waveguide. Attach the radio using the four (4) latches. Place the
supplied safety pins through the eyelets on the latches. A lock can be placed through a latch
eyelet if security is a concern.
Figure 2-16 Completed Non-Integral Antenna Mounting
2.4 .4.2
2.4 .4.22.4 .4.2
2.4 .4.2 Ground Leve l Assembly
Ground Leve l AssemblyGround Leve l Assembly
Ground Leve l Assembly
When access to the mounting pole is at a height making it necessary to assemble all
components at ground level, use the following procedure.
1.
Attach the radio to the antenna/bracket assembly and to the top half of the
antenna mount. Secure the four (4) latches and install the safety pins through
the latch eyelets. A lock can be placed through a latch eyelet should security be a
concern.
2.
Attach the V-clamp and bolts to the mount according to the relevant installation
drawing.
3.
Attach a lifting rigging to the entire assembly. The rigging must be capable of
safely lifting the entire assembly. The SL radio assembly weighs 13.2 kg [30 lb.]
with the 0.30m [12 inches] antenna and 17.8 kg [40 lb.] with the 0.6m [24 inches]
antenna.
4.
Raise the assembly to the position where the final mounting will be performed.
Attach the assembly to the pole.