User Manual
SRU Installation
17286-1000 Rev. B 03/14/01
SRU Inst alla tion Manual
2-5
2.3 .1
2.3 .12.3 .1
2.3 .1
SRU M ounting Proce ss
SRU M ounting Proce ssSRU M ounting Proce ss
SRU M ounting Proce ss
The SRU can be mounted on a pole.
When the SRU is installed onto a pole, first a pole mount (consisting of a mounting plate
and a strap) is installed onto the pole. The pole mount is the same for the 26 GHz, 28 GHz,
39 GHz, and 10 GHz SRUs. The appropriate SRU mount is then affixed to the pole mount.
The 26 GHz, 28 GHz, and 39 GHz SRUs use the same SRU mount. The 10 GHz SRU uses
a different SRU mount. The SRU is then affixed to the SRU mount.
2.3 .2
2.3 .22.3 .2
2.3 .2
Inst alling t he Pole Mount
Inst alling t he Pole MountInst alling t he Pole Mount
Inst alling t he Pole Mount
Use the following procedure for installing the pole mount to a pole of the specified
diameter prior to installing the SRU to the pole mount. A single pole mount design serves
the 26 G Hz, 28 G Hz, 39 G hz SRU mount and the 10 G Hz SRU mount.
1.
Prior to installation on the pole, assemble the pole mount using the instructions
supplied with the Pole Mounting Kit.
2.
Install three M10 bolts, lock and flat washer as shown in E rror! Reference
source not found.. Leave approximately 6.3-9.5 mm (.25-. 38 in) between the
flat washer and mounting plate. When using the M10 nuts, start the nut and
wind it down close to its final position. Then place a drop of anti-seize
compound on each bolt, making sure to cover the thread near the final nut
position when the nut is tightened.
3.
Orient the mounting-plate at an appropriate height and tighten it to the torque
specification. (Do not over tighten it.)
2.3 .3
2.3 .32.3 .3
2.3 .3
Inst alling a 26 GHz, 2 8 GH z, or 39 GH z SRU t o a Pole
Inst alling a 26 GHz, 2 8 GH z, or 39 GH z SRU t o a PoleInst alling a 26 GHz, 2 8 GH z, or 39 GH z SRU t o a Pole
Inst alling a 26 GHz, 2 8 GH z, or 39 GH z SRU t o a Pole
Install the 26G Hz, 28 GHz, or the 39 G Hz SRU mount, shown in Figure 2-1, onto the
mounting plate as follows:
1.
Align the three bolt clearance holes of the SRU mount with the three M10 bolts
started on the Mounting Plate.
2.
Place the SRU mount flush against the Mounting Plate.
3.
Slide the SRU mount down so the three M10 bolts slide into the bolt slots.
4.
Tighten the three M10 bolts to the torque spec.