User Manual

22
Items Information
Use Client certificate Client certificate for server authentication.
WPS AP List Display the information of surrounding APs with WPS IE from last
scan result. List information includes SSID, BSSID, Channel, ID
(Device Password ID), and Security-Enabled.
Rescan Click to rescan the wireless networks.
Information Display the information about WPS IE on the selected network. List
information include Authentication Type, Encryption Type, Config
Methods, Device Password ID, Selected Registrar, State, Version, AP
Setup Locked, UUID-E and RF Bands.
PIN Code 8-digit numbers. It is required to enter PIN Code into Registrar using
PIN method. Each Network card has only one PIN Code of Enrollee.
Config Mode Enrollee or an external Registrar.
Table of Credentials Display all of credentials got from the Registrar. List information
includes SSID, MAC Address, Authentication and Encryption Type. If
STA Enrollee, credentials are created as soon as each WPS success.
If STA Registrar, Utility creates a new credential with
WPA2-PSK/AES/64Hex-Key and doesn't change until next switching
to STA Registrar.
Detail Information about Security and Key in the credential.
Connect Command to connect to the selected network inside credentials.
Rotate Command to connect to the next network inside credentials.
Disconnect Stop WPS action and disconnect this active link. And then select the
last profile at the Profile Page of Utility if exist. If there is an empty
profile page, the driver will select any non-security AP.
Delete Delete an existing credential. And then select the next credential if
exist. If there is an empty credential, the driver will select any
non-security AP.
PIN Start to add to Registrar using PIN configuration method.
PBC Start to add to AP using PBC configuration method.
WPS associate IE Send the association request with WPS IE during WPS setup. It is
optional for STA.
WPS probe IE Send the probe request with WPS IE during WPS setup. It is optional
for STA.
Progress Bar Display rate of progress from Start to Connected status.
Status Bar Display currently WPS Status.
Note: When you click PIN or PBC, please don't do any rescan within two-minute connection. If
you want to abort this setup within the interval, restart PIN/PBC or click Disconnect to stop WPS
action.