User's Manual

22
Items Information
WPS AP List
Display the information of surrounding APs with WPS IE from last scan
result. List information includes
SSID, BSSID, Channel, ID (Device
Password ID), and Security-Enabled.
Rescan Click to rescan the wireless networks.
Information
Display the information about WPS IE on the selected network. List
information includes Authentication Type, Encryption Type, Config
Methods, Device Password ID, Selecte
d Registrar, State, Version, AP
Setup Locked, UUID-E and RF Bands.
Pin Code 8-digit numbers. It is required to enter PIN
Code into Registrar using PIN
method. Each Network card has only one PIN Code of Enrollee.
Click on
the Renew button to renew the PIN code.
Config Mode Enrollee or an external Registrar.
WPS Profile List Display all of credentials got from the Registrar. List information includes
SSID, MAC Address, Authentication and Encryption Type. If STA Enrollee,
credentials are created as soon as
each WPS success. If STA Registrar,
Utility creates a new credential with WPA2-PSK/AES/64Hex-
Key and
doesn't change until next switching to STA Registrar.
Detail Information about Security and Key in the credential.
Connect Command to connect to the selected network inside credentials.
Rotate Command to connect to the next network inside credentials.
Disconnect
Stop WPS action and disconnect this active link. And then select the last
profile at the Profile Page of Utility if exists. If there is an empt
y profile
page, the driver will select any non-security AP.
Delete
Delete an existing credential. And then select the next credential if exist.
If there is an empty credential, the driver will select any non-security AP.
PIN Start to add to Registrar using PIN configuration method.
PBC Start to add to AP using PBC configuration method.
WPS associate IE
Send the association request with WPS IE during WPS setup. It is
optional for STA.
WPS probe IE Send the probe request with WPS IE during WPS setup. It
is optional for
STA.
Progress Bar Display rate of progress from Start to Connected status.
Status Bar Display currently WPS Status.
Note: When you click PIN or PBC, please don't do any rescan within two-minute connection. If
you want to abort this setup within the interval, restart PIN/PBC or click Disconnect to stop WPS
action.