User Manual

AirMagnet A5200 Sensor User Guide
Chapter 2: Getting Started 9
A5200 Sensor RF Connectors
The A5200 Sensor comes with four reverse polarity RP-TNC RF
connectors, with two on each side, as shown in Figure 2-5. They are
intended for mounting four removable omni-directional dipole 2.4-/
5-GHz dual-band rubber-duck antennas.
Table 2-2: A5200 Sensor Interfaces
Interface Description
Power For supplying power to the Sensor using a DC 12V
universal adapter.
Note: This does not apply when PoE is used.
Reset • Pressing and holding down the button for less
than 5 seconds will reboot the Sensor.
• Pressing and holding down the button for more
than 5 seconds will reset the Sensor to its factory
default settings.
RJ-45 (Lan Port) For connecting the Sensor to an Ethernet
network through an RJ-45 Ethernet cable. The RJ-45
comes with built-in 802.3af PoE compliance.
RS-232 (Serial Port) For troubleshooting the Sensor using the
Hyperterminal.
A5200 Sensor User Guide.book Page 9 Thursday, January 15, 2009 2:00 PM