User's Manual
Table Of Contents
- Chapter I: Product Information
- CHAPTER II: Driver Installation and Configuration
- 2-1 Network Adapter Installation
- 2-2 Connect to Wireless Access Point
- 2-2-1 Using Realtek Utility
- NOTE: If you insert the USB wireless network adapter into an USB 3.0 port and connect to an 11ac AP, device driver will doing auto USB mode switch and shown the message as below photo, or you will heard sounds of USB insert or unplug, this is the norm...
- 2-2-2 Using Windows Zero Configuration
- 2-3 Connection Profile Management
- 2-3-1 Add a New Profile
- 2-3-2 Remove an Existing Profile
- If you have added a profile before, and you wish to change the content of the profile, you can use this function. Please select a profile from the list first, then click ‘Edit’ button. You’ll be provided with the contents of selected profile, and you ...
- 2-3-4 Make a Copy of an Existing Profile
- 2-4 View Network Statistics, General Information, and Status
- 2-4-1 General Information
- 2-4-2 Status
- 2-5 Miscellaneous Settings
- 2-6 Establish a Secure Connection with AP by WPS
- 3-1 Switch to AP Mode and Station Mode
- 3-1-2 Setup Soft-AP Security
- 3-2 Advanced Settings
- 3-3 Wireless Statistics
- 3-4 Internet Connection Sharing (ICS)
- 4-1 Hardware Specification
- 4-2 Troubleshooting
- 4-3 Glossary
40
CHAPTER III: Soft-AP Function
Excepting become a wireless client of other wireless access points, this
wireless adapter can act as a wireless service provider also! You can
switch this wireless adapter’s operating mode to ‘AP’ mode to simulate
the function of a real wireless access point by software, and all other
computers and wireless devices can connect to your computer wirelessly,
even share the internet connection you have!
Please follow the instructions in following chapters to use the AP function
of your wireless adapter.
3-1 Switch to AP Mode and Station Mode
The operating mode of the wireless adapter is ‘Station Mode’ (becoming
a client of other wireless access points) by default.
Please follow the following instructions to switch to AP mode:
1. Right-click Realtek configuration utility icon, and click ‘Open Config
Utility’.