User's Manual
Table Of Contents
- Chapter I: Product Information
- CHAPTER II: Driver Installation and Configuration
- 2-1 Network Adapter Installation
- 2-2 Connect to Wireless Access Point
- 2-2-1 Using Realtek Utility
- NOTE: If you insert the USB wireless network adapter into an USB 3.0 port and connect to an 11ac AP, device driver will doing auto USB mode switch and shown the message as below photo, or you will heard sounds of USB insert or unplug, this is the norm...
- 2-2-2 Using Windows Zero Configuration
- 2-3 Connection Profile Management
- 2-3-1 Add a New Profile
- 2-3-2 Remove an Existing Profile
- If you have added a profile before, and you wish to change the content of the profile, you can use this function. Please select a profile from the list first, then click ‘Edit’ button. You’ll be provided with the contents of selected profile, and you ...
- 2-3-4 Make a Copy of an Existing Profile
- 2-4 View Network Statistics, General Information, and Status
- 2-4-1 General Information
- 2-4-2 Status
- 2-5 Miscellaneous Settings
- 2-6 Establish a Secure Connection with AP by WPS
- 3-1 Switch to AP Mode and Station Mode
- 3-1-2 Setup Soft-AP Security
- 3-2 Advanced Settings
- 3-3 Wireless Statistics
- 3-4 Internet Connection Sharing (ICS)
- 4-1 Hardware Specification
- 4-2 Troubleshooting
- 4-3 Glossary
47
3-2 Advanced Settings
If you want to setup advanced settings of software access point, select
‘Advanced’ menu. If you don’t know the meaning and affects of these
settings, keep them untouched.
The description of all setup items are listed below:
Beacon Interval
Please input wireless beacon time interval here.
DTIM Period
Please input DTIM (Delivery Traffic Indication
Message) here.
Preamble Mode
Select wireless frame preamble mode (long or
short) from dropdown menu.
Set Defaults
Reset all settings back to factory default value.
Apply
Save changes.
If you changed any setting here and cause problem on communicating
with wireless clients, click ‘Set Defaults’ to reset all settings back to
default setting.