User's Manual

5. Setting up Z308

5-1. Turn On/ Turn Off Z308

To manually turn on or turn off Z308, please use the following instructions:

A. Turn it on: Press and hold the Panic Button for 3 seconds. The indicators will flash once, and the

device is ready to be used.

y When ZB02C is in a ZigBee network → the indicator will flash green 5 times.

B. Turn it off: Press and hold the Panic Button for 6 seconds. The indicator will flash red 10 times

within 5 seconds. Within the 5-second period of time, press the Panic Button again to turn it off.

5-2. Join the ZigBee Network

After Z308 is turned on, it will search for an existing ZigBee network and send a request to join the network

automatically. While Z308 is under the coverage from a coordinator or a router whose permit-join feature is

enabled, Z308 will be permitted to join the network.

Step1. Enable the permit-join function (valid for 60 seconds) of a coordinator or a router (please refer to

the user manual of the coordinator or the router to enable the permit-join feature).

Step2. Turn on Z308. It will start to search and join the network.

Step3. The indicator will flash green once when it finds out a network to join.

Step4. The indicator will flash green 5 times after it is joined successfully. Otherwise, the indicator will

not flash.

Step5. When Z308 cannot join a network in 25 seconds, it will go into turn-off mode.

y After joining a network, Z308 would try to enroll in the ZigBee security system. Please make sure Z308

and CIE (Control and Indicating Equipment) device have enough power.

5-3. Enroll in the ZigBee Security System

Z308 is a Zone device in the ZigBee security system. Right after Z308 join the ZigBee network, it will

automatically find out a CIE (Control and Indicating Equipment) device (i.e. Netvox Z201B) and send a

registration request to the CIE device to enroll in the security system. The enrollment has these 3 situations:

A. There is no CIE device or no compatible CIE device in the network → the indicator flashes red twice.

B. There is a compatible CIE device in the network, but it is failed to enroll → the indicator flashes red 4

times. Users can reboot Z308 to initiate the registration.

C. The enrollment is completed → the indicator flashes red 6 times.

NOTE: Users had better NOT enroll multiple Zone devices at the same time to prevent registration failure.