Computer Accessories User Manual

15
Installing NCDware on WinCenter Systems
The procedure in this section is required for NT-only networks. If
your
NCD network computers (also called terminals) are on an
NT-only network, you need to install NCDware on a WinCenter
server so it can act as a boot server for the
NCD terminals.
The instructions below describe how to install
NCDware on a
WinCenter server running WinFrame 1.6 or later. For information
about WinCenter, see WinCenter product documentation. For
additional information about using and configuring
NCDware, see
NCDware documentation.
Using setup
To install NCDware you need:
❏ A WinCenter server equipped with a CD-ROM drive and running
WinFrame 1.6 or later
❏ Approximately 10 minutes for the installation
Note For information on space requirements, see the Release
Notes or the file
SIZES on the CD-ROM.