User's Guide

3
NetSmart User Guide v1.0 tantiv4.com
Back View
Ports (Right to Le)
1. Power port: Connect the included AC power adapter.
2. Reset buon: Press and hold for 10 seconds (un the power LED starts shing) to reset the router to
factory sengs.
3. Internet port: Connect an Ethernet cable to this blue gigabit (10/100/1000) port, and to a broadband
Internet cable/DSL or ber modem.
4. LAN ports—Connect Ethernet cables to these yellow gigabit (10/100/1000) ports, and to wired devices on
your network.
5. Adjustable antennas
—
This router ships with four adjustable external antennas that should be connected
to the router before powering it on.
Note—For best performance, posion the side antennas vercally as shown in the picture above.
2
NetSmart User Guide v1.0 tantiv4.com
Product Overview
Top View
Led Indicators (Right to Le
1.
Power indicator: The icon LED is solid green while the router is powered on. It will blink when the router
goes through its self-diagnosc mode during every boot-up.
2.
2.4 GHz Indicator: The Wireless LED is solid green when one or more clients are connected to the 2.4 GHz
network. If the LED is blinking green, the router is sending or receiving data over the 2.4 GHz network.
3.
5 GHz Indicator: The Wireless LED is solid green when one or more clients are connected to the 5GHz
network. If the LED is blinking green, the router is sending or receiving data over the 5 GHz network.
4.
Internet Indicator: The Internet LED blinks green while the router works to establish a connecon.
5.
WAN Indicator: The Internet LED is solid green when connected to the Internet. If the LED is blinking
green, the router is sending or receiving data.
6.
LAN 1 through 4: These numbered LEDs correspond with the numbered ports on the router’s back panel.
If the green LED is solid, the router is connected to a device through that port. A shing green LED
indicates network acvity over that port.
4
NetSmart User Guide v1.0 tantiv4.com
Seng Up
How to install your router
1. Turn the antennas, so they are posioned straight up and plug in your router to a power source.
2. Connect the Internet cable from your modem to the blue WAN port on your router. Wait unl the
indicator light on your router is solid.
3.
Connect to the secure wireless SSID “Tanv4 Rezrv 2G YH” or “Tanv4 Rezrv 5G YH”
4.
Password for connecon “tanv@4”
5. To open the webpage, go to 10.3.12.1 on your computer’s web browser
NetSmart
Quick Install Guide