NTI R 1275 Danner Dr Tel:330-562-7070 NETWORK TECHNOLOGIES Aurora, OH 44202 Fax:330-562-1999 www.networktechinc.
TRADEMARK CRYSTALMON is a trademark of Network Technologies Inc in the U.S. and other countries. COPYRIGHT Copyright © 2005, 2008 by Network Technologies Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written consent of Network Technologies Inc, 1275 Danner Drive, Aurora, Ohio 44202.
TABLE OF CONTENTS Introduction.................................................................................................................................................................... 1 Overview ...................................................................................................................................................................... 1 Features.................................................................................................................................
TABLE OF FIGURES Figure 1- Mount CM-RK17 to a rack ............................................................................................................................... 6 Figure 2- Mount CM-WL17 to an arm or bracket ............................................................................................................ 7 Figure 3- Secure cables to power supply bracket...........................................................................................................
NTI CRYSTALMON TFT/LCD MONITOR INTRODUCTION Overview The CRYSTALMON series TFT/LCD monitors provide the industrial or commercial user with superior picture quality, multiple video formats, and a sturdy industrial enclosure. It also offers several mounting options, as well as the ability to integrate with existing NTI products. The CRYSTALMON monitor can be ordered with provisions for rack, wall, or tabletop mounting.
NTI CRYSTALMON TFT/LCD MONITOR MATERIALS Materials supplied with this kit: 9 9 9 9 9 9 9 9 9 NTI CRYSTALMON TFT/LCD Monitor 120 or 240VAC at 50 or 60Hz-12VDC/5A via AC Adapter Power Supply Holder 2- Cable clamps 4- #4-40 x 3/16” black Phillips-panhead screws 6 foot VGA cable-VEXT-6-MM (15HD male-male connectors) 6.
NTI CRYSTALMON TFT/LCD MONITOR PRECAUTIONS • • • • • • • • • Do not apply pressure to the display portion of the CRYSTALMON because the LCD panel and backlight can be easily damaged. Do not cover or block the vent holes in the case. Be sure to turn OFF the power supply before connecting and disconnecting video source cable(s). Be careful not to drop the CRYSTALMON. Handle it carefully. Do not store or install the CRYSTALMON where it can come in contact with moisture as moisture may damage the CRYSTALMON.
NTI CRYSTALMON TFT/LCD MONITOR FEATURES AND FUNCTIONS 1 2 3 4 5 6 NTI CRYSTALMON TM Main Controls 1. Power Button- to turn the LCD and backlight ON and OFF. 2. Power LED- to indicate the power status of the monitor Green= Power On, Video Input OK Red= Suspend/Standby, or Input Out of Range 3. Menu Button- to open OSD menu (when OSD menu is OFF) 4. Arrow Up Button- to move the selection cursor in the OSD menu up in the list 5.
NTI CRYSTALMON TFT/LCD MONITOR REAR VIEW OF CRYSTALMON NTI 10 R NETWORK TECHNOLOGIES INCORPORATED 1275 Danner Dr Tel:330-562-7070 Aurora, OH 44202 Fax:330-562-1999 www.networktechinc.com - 12VDC 5A + DVI 7 8 VGA 9 7. 12VDC Power Jack- for connection of AC adapter 8. DVI Video Port- DVI-D female- for connecting DVI type video source 9. VGA Video Port- 15HD female- for connecting VGA type video source 10.
NTI CRYSTALMON TFT/LCD MONITOR INSTALLATION Mounting Mount the CRYSTALMON as intended for the application. Rack Mount Secure the CRYSTALMON (model CM-RK17) to a rack using appropriate hardware through the holes provided (see Fig. 1). Mount using at least two screws on each side. Front View of CM-RK17 Figure 1- Mount CM-RK17 to a rack Wall Mount- with Arm Mount the selected Wall Mount LCD Arm or bracket assembly to the wall.
NTI CRYSTALMON TFT/LCD MONITOR Alternate Power Supply Bracket location Keyholes for mounting directly to the wall Hole pattern for 75mm mounting Hole pattern for 100mm mounting Note: Use only M4 x 10mm screws (provided) in 75mm or 100mm mounting holes. Use of longer screws may damage the CRYSTALMON. Power Supply Bracket NTI R NETWORK TECHNOLOGIES INCORPORATED 1275 Danner Dr Tel:330-562-7070 Aurora, OH 44202 Fax:330-562-1999 www.networktechinc.
NTI CRYSTALMON TFT/LCD MONITOR Power Supply Bracket A power supply bracket has been supplied for the convenient mounting of the power supply for the CRYSTALMON. This bracket can be directly mounted to the CRYSTALMON. Two possible mounting locations are shown in Fig. 2 on Page 5. Two #4-40 x 3/16” black screws have been supplied to secure the bracket to the back of the CRYSTALMON.
NTI CRYSTALMON TFT/LCD MONITOR Power Up 1. Connect the AC adapter to the power jack on the CRYSTALMON. Make sure the power connector is fully inserted. 2. Plug the AC adapter into a power source and press the power button to power up the CRYSTALMON. 3. If the video source(s) are not yet ON, apply power to them at this time. Power Button REAR VIEW OF CRYSTALMON NTI R NE TWORK TECH NOLOGIES INC OR PORATED 12 75 Danne r Dr Tel:3 30-5 62-70 70 Aurora, OH 44 202 Fax:33 0-562 -1999 www.networktec hinc.
NTI CRYSTALMON TFT/LCD MONITOR DISPLAY FUNCTIONS The CRYSTALMON 17” monitor supports resolutions up to SXGA (1280x1024) with a refresh rate at between 55 and 76Hz. The quality of the image on the LCD monitor is adjustable using an On Screen Display (OSD) menu using the control buttons on the CRYSTALMON. Standard Controls • The CRYSTALMON has 5 standard control buttons and a power LED.
NTI CRYSTALMON TFT/LCD MONITOR OSD Control Menu The OSD (On Screen Display) Menu enables the user to select the desired characteristics of the LCD display. To activate the OSD Menu, press the Menu button (above). To turn the Menu back OFF, either select "EXIT" from the main menu or just wait 10-60 seconds and it will automatically be cleared from the screen. Any changes made before exiting the menu will be saved.
NTI CRYSTALMON TFT/LCD MONITOR Setup Menu Selecting the Setup menu will bring up a screen in which the user can adjust OSD POSITION-the position of the OSD menus on the LCD display (positions 0-4) OSD TIME-the length of time the user can be idle before the OSD menu automatically exits (adjustable from 10 to 60 seconds) LANGUAGE-the language that the OSD menus will be presented in INPUT SOURCE- the type of signal that is coming from the input source, either Digital (DVI) or PC (VGA) With the item hi
NTI CRYSTALMON TFT/LCD MONITOR SPECIFICATIONS LCD Display area………………………………..337.92mm (W)x270.336 (H) (17 inch diagonal) Panel Type…………………………………TFT Active Number of Pixels .....................................1280 (H)x1024 (V) Number of Colors ....................................16.2 Million (6 bits + FRC) Pixel Pitch................................................0.264(H)x0.264(V) Color Pixel Arrangement.........................RGB Vertical Stripe Brightness................................................
NTI CRYSTALMON TFT/LCD MONITOR DIMENSIONS 16.5" 3.7" 12.
NTI CRYSTALMON TFT/LCD MONITOR 3.7" 19" 12.25" SIDE VIEW FRONT VIEW CM-RK17 TROUBLESHOOTING Problem Power LED is OFF Power LED is red Power LED is green, but there's no picture Solution Check to see if AC adapter is fully inserted Check connections of video source cables Make sure video sources are switched ON Check to see if Horizontal Sync is out of range.
NTI CRYSTALMON TFT/LCD MONITOR WARRANTY INFORMATION The warranty period on this product (parts and labor) is two (2) years from the date of purchase. Please contact Network Technologies Inc at (800) 742-8324 (800-RGB-TECH) or (330) 562-7070 or visit our website at http://www.networktechinc.com for information regarding repairs and/or returns. A return authorization number is required for all repairs/returns. MAN058 16 Rev.